T200, T380, or T680 Transporter Replacement
August 2012 Replacing the Transporter—Spectra T200, T380, and T680 Libraries
9
Use the following steps to power off the library.
1. Power off the library from the front panel.
Note: Refer to the Spectra Mid-Range Libraries T200, T380, and T680 User
Guide for instructions if the BlueScale Soft Power option is
enabled.
a. Press the front panel power button for approximately six seconds or
until the button’s LED starts flashing.
b. Wait for the power-off sequence to complete. It takes from one
minute to five minutes (depending on the library) while the library
allows the BlueScale software to shut down gracefully.
2. Set the main power switches on the library back panel to the off
position and disconnect the AC power cords.
Notes: If you have redundant power supplies installed, make sure
you turn off both power switches.
If you have cable locks installed on the power cords, it is
easier to disconnect the cords from the AC outlets at the wall.
Figure 3 Press and hold the front panel power button.
Figure 4 Turn off the library AC power switches and disconnect the power cords.
Main AC
AC power
switch
Main AC
switch
cord
AC power
cord
To Next Page
Loading...
