Spectra T200 - Access the Transporter; Access the Transporter from the Front

T200, T380, or T680 Transporter Replacement Access the Transporter
August 2012 Replacing the Transporter—Spectra T200, T380, and T680 Libraries
10
ACCESS THE TRANSPORTER
The procedure for accessing the transporter depends on how the library is
installed.
 Access through the front panel—If the library’s right side panel is
inaccessible, you must perform the replacement procedure through the
front of the library. See Access the Transporter from the Front,
beginning on this page, for instructions. This is the most common
method of access.
 Access through the right side panel—If you have access to the library’s
right side panel, you can perform the replacement procedure by
removing the access panels, as described in Access the Transporter
from the Right Side on page 15. This access method simplifies the
replacement procedure.
Access the Transporter from the Front
If you cannot access the right side of the library, use the instructions in the
following sections to remove the front panel, fan assembly, and shelves.
Remove the Front Panel
1. From the front of the library, pull firmly outward on the top edge of the
filter cover panel to release the magnetic latches and tip the cover out
from the front panel.
2. Lift the cover upward to disengage the tabs on each side of the cover
from the slots in the front of the library. Set the cover aside.
Important
Do not remove the library from the rack.
Figure 5 Remove the filter cover
panel.
Pull outward
Lift upward
Tab