T200, T380, or T680 Transporter Replacement Reassemble the Library
August 2012 Replacing the Transporter—Spectra T200, T380, and T680 Libraries
30
5. Engage the tabs with the slots in the front of the library, then slide the
cover downward. Push the upper edge of the cover toward the front
panel until the magnets secure it to the front panel.
6. Proceed to Power On the Library on page 31.
Reassemble From the Right Side
If you accessed the transporter from the right side of the library, use the
following steps to reinstall the access panels on the right side of the library.
1. If you chose not to power off the library and instead removed the front
panel to turn off the 24 VAC power, first reinstall the front panel as
described in Install the Front Panel on page 28. When you finish
installing the front panel, return to these steps.
2. Slide the top edge of the upper access panel into the slots on either side
of the chassis so that the locking tabs on each side of the panel engage
the top edge of the chassis.
Note: The upper access panel can be identified by the lip on its lower
edge. This lip fits under the top edge of the lower access panel.
3. Align the screw holes on the top edge of the upper access panel (circled
in Figure 13 on page 16) with the screw holes in the chassis. Use a #2
Phillips screwdriver to install the screws securing the cover to the
chassis.
4. Position the lower access panel with the notched edge down, aligning
the holes on the top edge of the panel (circled in Figure 13 on page 16)
with the corresponding holes in the chassis. Use a #2 Phillips
screwdriver to install the screws securing the cover to the chassis.
5. If you removed the right-hand access panel from the rack in Step 1 on
page 15, reinstall the panel using the screws you removed earlier.
Figure 31 Install the filter cover.
Push inward
Slide downward
Tab
To Next Page
Loading...
