T200, T380, or T680 Transporter Replacement Reassemble the Library
August 2012 Replacing the Transporter—Spectra T200, T380, and T680 Libraries
29
c. Fit the alignment pin on the top edge of the panel and the two nuts
extending from the back of the front panel into the corresponding
holes on the edges of the chassis.
Note: Make sure that the power button fits into the cutout in the front
panel and that the front panel is flush against the front of the
chassis.
2. Using your fingers or a #2 Phillips screwdriver, tighten the two captive
screws on the bottom of the library front cover to secure it to the
chassis.
3. Position the tabs on the back of the filter cover over the slots in the front
cover.
4. Make sure that the air filter is positioned on the inside of the filter
cover.
Figure 29 Install the front panel on the chassis.
Alignment nut on
front panel
Figure 30 Tighten the front panel screws.
Captive
Slot for
filter cover
Slot for
filter cover
screws
To Next Page
Loading...
