Spectra T200 - Page 28

T200, T380, or T680 Transporter Replacement Reassemble the Library
August 2012 Replacing the Transporter—Spectra T200, T380, and T680 Libraries
28
3. Reinstall the fan assembly.
a. Orient the fan assembly with the gasket material toward the outside
and the captive screw to the left.
b. Angle the right edge of the assembly behind the front right edge of
the chassis so that the notches in the edge of the assembly fit over
the PEM nuts on the chassis.
c. Finger-tighten the captive screw (see Figure 8 on page 12) on the left
side of the fan assembly to secure the assembly to the chassis.
Install the Front Panel
1. Grasp the left and right edges of the front panel and lift it into position
on the front of the chassis.
a. Align the cutouts for the touch screen and the TAP with the front of
the library.
b. Insert the alignment pin on the bottom edge of the front panel into
the corresponding hole in the bottom edge of the chassis.
Figure 28 Install the fan assembly.
Front edge of chassis
PEM nuts