Spectra T200 - Reassemble the Library; Reassemble from the Front

T200, T380, or T680 Transporter Replacement Reassemble the Library
August 2012 Replacing the Transporter—Spectra T200, T380, and T680 Libraries
25
REASSEMBLE THE LIBRARY
After you finish installing the new transporter, follow the steps in the
following sections to reassemble the library.
 If you installed the transporter from the front of the library, begin with
Reassemble From the Front, below.
 If you installed the transporter from the right side of the library, begin
with Reassemble From the Right Side on page 30.
Reassemble From the Front
If you accessed the transporter from the front of the library, follow the
instructions in the following section to reinstall the fan assembly, chamber
shelves, and front panel.
Install the Chamber Shelves and Fan Assembly
1. Reinstall each shelf that you removed.
a. Orient the back of the shelf toward the inside of the library.
Figure 24 Orient the back of the shelf toward the interior of the library.
Outer media
Front tab
guide
Outer media
guide
Front tab
Cutout
Front of shelf