10
E-DOC-CTC-20050705-0001 v1.0
Chapter 2
Installing your SpeedTouch™
2.4 Installing your SpeedTouch™ in Mac OS X
The SpeedTouch™
installation
The SpeedTouch™ installation consists of two major parts:
“ To install the SpeedTouch™ software”
“ To install the SpeedTouch™ hardware”
If you want to connect to the Internet via a PPP (PPPoA or PPPoE) connection, some
additional configuration is required.
Mac OS X differences Depending on the Mac OS X version on your computer, some windows may differ
from the windows shown in the installation procedures. When you’re in doubt about
your Mac OS X version, click the Apple ( ) menu and choose About This Mac.
To install the
SpeedTouch™ software
Proceed as follows:
1 Make sure you are not using any other applications.
2 Make sure you have the connection details from your Internet Service Provider
(ISP) at hand.
3 Insert the SpeedTouch™ Setup CD into your computer's CD-ROM drive.
4 Double-click the file Menu on the Setup CD.
5 Select the language in which you wish to see the installation instructions.
6 Follow the installation instructions on your screen.
7 Observe the following tips:
If your computer runs Mac OS X v10.1 or v10.2, the installation wizard
may prompt you for authentication. If this is the case, click to enter
your credentials.
If your computer runs Mac OS X v10.3 or v10.4, your computer will
prompt you to run a program to determine if the installer package can be
installed. Click Continue.
If you inserted the Setup CD into your computer during previous
sessions without installing the SpeedTouch™, the SpeedTouch™
CD Menu window apprears diectly. In that case, you must click
SpeedTouch Maintenance in the SpeedTouch™ CD Menu and click
(Re-)install my SpeedTouch to start the installation.
To Next Page
Loading...