SYSTEM SETTINGS
System settings allows adjustments to the following transmitter settings:
DISPLAY
User Name
The User Name field displays your name above the model name on the main screen.
1. Scroll to the desired letter position and click the scroll wheel once. A flashing box appears.
2. Scroll Up or Down until the desired character appears. Click the scroll wheel once to save the character.
3. Scroll to the next desired letter position. Repeat Steps 1 and 2 until the Model Name is complete.
Contrast
To adjust the screen contrast:
1. Scroll to Contrast and click the scroll wheel.
2. Scroll Up or Down to adjust the contrast value. Lower numbers lighten the contrast, higher numbers
darken it.
3. Click the scroll wheel once to save the selection.
Backlight:
The Backlight field adjusts the backlight appearance time and brightness. You have the option to turn the
backlight On or Off or set how long the display stays lit (3, 10, 20, 30, 45 or 60 seconds).
Battery:
Select from Alka (default), LiIon, LiPo or NiMH battery types. Note that when the battery type is changed the
Battery alarm automatically changes for the correct type of battery chemistry.
DRIVE MODE
Every model can have up to 4 drive modes programmed to a switch or button for On-The-
Fly adjustments.
Once a drive mode is selected, changes to model setup, trim and timers will only affect that drive mode.
1. Select the On The Fly (OTF) switch to switch between drive modes.
2. Scroll down to Modes; Drive Mode 1 and click the scroll wheel to rename the mode if desired.
3. Select the (+) to add a new Drive Mode.
TELEMETRY
The telemetry screen allows for easy access to all telemetry sensors and settings.
To add telemetry sensors:
1. Select an empty slot.
2. Push the scroll wheel once and scroll to find the desired telemetry sensor.
3. Click the scroll wheel to save the selection.
To edit telemetry sensors:
1. Select the sensor from the list.
2. Push the scroll wheel once to open that sensors settings.
3. Adjust sensor parameters.
4. Click the scroll wheel to save the selection.
Settings: Chose how telemetry is displayed on the transmitter.
File Settings:
• Displays File name of saved telemetry files.
• Inhibit, activate telemetry file saving.
FUNCTION LIST
• Display
• Trims
• Sounds
• About
• Calibrate
To Next Page
Loading...
Need help?
General
