Operator Manual - Spider ILD02 SG
30 / 51 rev. 01-01-04-2011
10.8 DRIVING THE MACHINE
The machine movement is controlled by
joystick (8) (forward and reverse) (see the
symbol under the controller on the remote
radio controller) and by joystick (9) (Left/
right). By combining these two controls you
will be able to control the machine.
When these joysticks are moved, the
machine either accelerates or steers.
NOTICE:
Accelerate slowly so as to be
able to react to the direction in
which the mower starts to move. The V
shaped tread pattern on the tyres denotes
the direction the machine will move when
forwards motion is selected.
When driving, slowly move the joystick in
the desired forward or reverse direction.
When changing the forward motion to
reverse motion, always leave the joystick
for a short moment in the neutral positron.
When driving the mower,
always set the maximum
engine speed. Driving with any
lower engine speed is
prohibited.
In cold weather let the engine run for about
2 minutes to allow the oil to get warm
before driving.
10.9 DRIVING SPEED OF THE
MOWER
Always choose a suitable driving speed,
which enables an acceptable mowing
quality. When selecting speed, always start
with slow and proceed to fast, not the other
way around. If the growth is thin, you may
mow at higher speed.
To control the driving speed you can also
use the driving speed controller (2), which
lets you choose between high (rabbit) and
low (turtle) driving speeds. When starting to
operate, always use the low (turtle) speed
range. Also choose the low speed range
when mowing either slopes steeper than 20
degrees or an uneven terrain.
Never reduce the driving speed by
reducing the engine speed!!!
Always use joystick (8) to reduce
the speed.
Higher speed range: 0-8 km.h
1
/ 0-5 mph
Lower speed range: 0-3 km.h
1
/ 0-2 mph
IT IS PROHIBITED to drive on
slopes steeped than 20 degrees with
the mowing device engaged and the
controller switched to the high-speed
(rabbit) position.
IT IS PROHIBITED to switch to the
high-speed position while mowing.
Stop the machine before selecting a
different speed range.
To Next Page
Loading...
