SPIDER ILD02 SG - WHEEL CHANGING AND TYRE PRESSURE MAINTENANCE

Operator Manual - Spider ILD02 SG
40 / 51 rev. 01-01-04-2011
11.16 CHANGING THE WHEEL
Change the wheels on a level, firm surface
Turn the wheel so that the tightening nuts
are accessible from the outside
Stop the engine, remove the key from the
ignition
Secure the machine against movement.
Lift the mower and support it under the
cutter deck
Ensure the machine safe & supported
before working on it.
Loosen the wheel nuts, remove the wheel
After repairing it, attach the wheel back in
the reversed order.
Use suitable tools to unscrew the nuts
11.17 TYRE PRESSURE
Keep the specified tyre pressure. Other values may
unfavourably influence the riding characteristics
especially on slopes. You may even lose control of the
machine.
(Max. tire pressure - 250 kPa / 2.5 bar / 36 PSI)
11.18 MOWING HEIGHT ADJUSTMENT MECHANISM
Keep the moving parts of the slide way clean,
undamaged and without an excessive clearance