Operator Manual - Spider ILD02 SG
32 / 51 rev. 01-01-04-2011
Machine Maintenance Plan
údržby stroje
Visually check for oil leakage from engine and
hydraulic systems
Grease all sliding bars (at least once a season)
Lubricate other lubrication points with dry lubricant in
a spray
Check the level of hydraulic oil in tank
Visually check the tension of travel V-belts
Visually check the tension of the steering chain
Check the remote control battery state of charge
Check the mower battery state of charge
Check electronic and safety devices (emergency stop,
steering, signal etc.)
Check screw and nuts tightening (visually check daily)
Check blade sharpness and deformation
Check the blade bolts tightening
Change the hydraulics filter
(Ecological oil - first exchange after 200 OH)
Rinse the fuel tank, change the breather filter
Change the fuel filter (change more often on extremely
dusty or dirty conditions)
Clean cooling systems (engine, hydraulic pump)
Visually check hydraulic hoses, fuel hoses, cables –
replace if necessary
Check and adjust wheel geometry
Adjust the neutral position of the machine drive
(hydraulic pump)
Check, adjust and tighten chains in the wheel
suspensions
Adjust the blade deceleration
Check drive belts and mowing mechanism belts –
replace if necessary
Check and clean the mowing mechanism gear (belts,
pulleys, belts pulleys)
Check safety decals on the machine
Check the mowing device bearings
Check the Brake lining condition
Adjustment of the auxiliary drive by an authorized
x
11 MAINTENANCE AND LUBRICATION
11.1 MAINTENANCE CAHRT - MOWER
To Next Page
Loading...
