Spirax Sarco LC2650 User Manual

IM-P402-128 EMM Issue 7
67
12. Menu map
STOP
CLOSE
OPEN
MODE
PASSCO DE
PUMP OFF
PUMP ON
LEVELINPUT SENSOR 1-6 V
4-20 mA
OUTRANGE OFF
ON
FI LT ER 2 (SEC)
INTEGRAL OFF
ON 120 (SEC)
CTL BAND 20 %
SP 50 %
CAL MIN
MAX
POT CAL MIN
MAX
STEAM OFFSET 0
100
% %MAX
W/METER OFF
0 % (MAX)ON
DRIVE CONTROL PROP
ON / OFF
OUTPUT
ACTION PUMP IN
PUMP OUT
TYPE VMD
4-20 mA
10 %DEADBAND
RETRANS 0 OR 4 mA 4 mA
0 mA
000 (%)SET 4 mA
100 (%)20 mA
CHECK 4 mA ADJUST
20 mA ADJUST
POSITION 0 OR 4 mA 4 mA
0 mA
000 (%)SET 4 mA
100 (%)20 mA
CHECK 4 mA ADJUST
20 mA ADJUST
COMMS ADDRESS 001
9600BAUD
SlaveIR COMMS
ALARM 1 HI OR LO HIGH
LOW
PV 90 %
HYST 5 %
DE L AY 0 SEC
LATCH OFF
ON
ALARM 2 HI OR LO HIGH
LOW
PV 10 %
HYST 3 %
DE L AY 0 SEC
LATCH OFF
ONTEST DIS PLAY
INPUT INT TEMP 70
PV XX.XX
FEEDBACK XX.XX
FLOW XX.XX
STEAM XX.XX
mV mV
mA mA
OUTPUT RETRANS 12 mA
POSITION 12 mA OFF
VA LVE + VA LVE ON
-VALV E ON
OFF
SW. VER 1
SET PASS 8888 ONPUMP
OFF
ALARM ON
OFFCA N CE L?
TREND MINS
HRS
DAYS
Run display mode PV SP CTL BAND AL 1 HIGH AL 1 SYST AL 1 DEL AL 2 LOW AL 2 HYST AL 2 DEL OFFSET FLOW (ERROR)
Visible if VMD is selected and W/ METER is not selected
Invisible if OFFSET = 0 Invisible if OFF selected
Invisible if ON-OFF control selected
Visible only when OUTPUT-DRIVE- CONTROL-PROP is selected refers to percentage of valve stroke
100% = fully open, 0% = closed
Only visible if TYPE 4-20 mA is selected rather than VMD
Invisble if VMD is selected
VALVE or PUMP sub -menu are shown depending on which control is selected. + VALVE and -VALVE, tests the relay in the ON or OFF position. Selecting a +VALVE test will cancel a -VALVE and vice versa. Note: Selecting ON or OFF will return you to the original sub-menu (+VALVE or -VALVE)
Master
°C
Only visible when
ON /OFF control
is selected
Note
The up and down but tons allow the
operator to scroll up and down.

Spirax Sarco LC2650 Specifications

General

Brand	Spirax Sarco
Model	LC2650
Category	Controller
Language	English