IM-P323-32
CTLS Issue 5
9
SX80 and SX90 Quickstart Guide
1.1 Intended use
i) Check that the product is suitable for its intended application.
ii) Check material suitability, pressure and temperature and their
maximum and minimum values. If the maximum operating limits
of the product are lower than those of the system in which it is
being fitted, or if malfunction of the product could result in a
dangerous overpressure or overtemperature occurrence, ensure
a safety device is included in the system to prevent such over-
limit situations.
iii) Determine the correct installation situation and direction of
fluid flow.
iv) Spirax Sarco products are not intended to withstand external
stresses that may be induced by any system to which they are
fitted. It is the responsibility of the installer to consider these
stresses and take adequate precautions to minimize them.
v) Remove protection covers from all connections and protective
film from all name-plates, where appropriate, before installation
on steam or other high temperature applications.
1.2 Access
Ensure safe access and if necessary a safe working platform
(suitably guarded) before attempting to work on the product.
Arrange suitable lifting gear if required.
1.3 Lighting
Ensure adequate lighting, particularly where detailed or intricate
work is required.
To Next Page
Loading...
