IM-P736-02 EMM Issue 3
12
VLM30 In-Line Vortex Flowmeter
Flanged devices ≤ DN300
-
Use carrying straps to transport flange designs smaller than DN350.
-
Wrap the carrying straps around both process connections when lifting the device. Chains should not
be used, since these may damage the housing.
Flange devices > DN300
-
Using a forklift to transport flange device can dent the housing.
-
Flange devices must not be lifted by the center of the housing when using a forklift for transport.
-
Flange devices must not be lifted by the terminal box or by the center of the housing.
-
Only the transport lugs fitted to the device can be used to lift the device and insert it into the piping.
Storing the device
Bear the following points in mind when storing devices:
-
Store the device in its original packaging in a dry and dust-free location.
-
Observe the permitted ambient conditions for transport and storage.
-
Avoid storing the device in direct sunlight.
-
In principle, the devices may be stored for an unlimited period. However, the warranty conditions stipulated
in the order confirmation of the supplier apply.
Ambient conditions
The ambient conditions for the transport and storage of the device correspond to the ambient conditions
for operation of the device.
Refer to Ambient conditions in Section 3.7.
Returning devices
For the return of devices, follow the instructions in Section 8.1 Replacing the transmitter, Section 8.2 Removal
from the line, and Section 1.15 Returning products.
To Next Page
Loading...
Need help?
General
