EasyManua.ls Logo

SPORTSTECH sTread - Troubleshooting; Cleaning and Maintenance

SPORTSTECH sTread
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
28
5. Cleaning and maintenance
5.1 CLEANING
After each use, wipe sweat from the device with a slightly wetted cloth.
Never allow moisture or humidity to reach the computer or other electrical or electronic components.
Do not use abrasives or solvents.
5.2 MAINTENANCE
Before and after each training session, check that the device is in perfect condition. Also check that
all fastening parts and protective covers are in place and intact. Tighten bolts and nuts if necessary.
5.3 LUBRICATING
For proper functioning and long life of the device, the running belt must be adequately lubricated with
silicone oil. There are thin tubes on the underside of the device as a lubrication system.
5.3.1 Lubrication and inspection intervals
Refill with silicone oil after the first 25 hours of operation (or 2-3 months).
Check the lubrication regularly.
Top up with silicone oil at least every 50 operating hours (or 5-8 months).
Run on the treadmill at a slow speed for 3 to 5 minutes to evenly distribute lubricant.
5.3.2 Checking lubrication
Make sure that the electrical supply plug of the device is disconnected.
Lift the running belt on one side. Run your finger over the top of the running deck under the running
belt.
- If the running deck feels slightly oily, the lubrication is sufficient
- However, if the running deck feels dry, you need to top up with silicone oil.
4. Troubleshooting
Problem Possible reason Possible solution
Device does not switch
on or does not start
Power cable not plugged in Plug in the power cable
Safety Tether Key is not correctly
installed
Reinstall the Safety Tether Key.
Circuit breaker in the house has been
tripped .
Reset the circuit breaker, or call an
electrician to replace the circuit
breaker.
Treadmill circuit breaker has been
tripped.
Wait 5 minutes and then try to
restart the treadmill.
Running belt slips Running belt not tightened enough Tension the running belt
Running belt faltering
during use
Running belt not lubricated enough Refill silicone oil
Running belt too tight Relax the running belt
Running belt not
centred
Running belt unevenly tensioned Adjust the running belt centrally
In all cases of doubt, contact our customer service. You find the contact details on the last page.

Table of Contents

Related product manuals