6
2. GETTING STARTED
hardness
Depending on the water hardness in the area, the machine needs
to be descaled every now and again. For the system to be able to
indicate that this is necessary, set the correct water hardness prior
.
First test the water quality with the enclosed test strip.
Dip the test strip into the water and shake it lightly.
After about one minute read the result by counting the red dots
on the test strip.
The dierent levels are listed as follows and can be adjusted:
1 red dot/1–7° = LEVEL 1 = 1 red bar
2 red dots/8–14° = LEVEL 2 = 2 red bars
3 red dots/15–21° = LEVEL 3 = 3 red bars
4 red dots/>21° = LEVEL 4 = 4 red bars
Press steam/rinsing button (Fig. 1/E) for more than three seconds
to go to main menu.
Symbol S7
and up to three bars light up at the bottom of the display.
By pressing the coee cup button (Fig. 1/D) repeatedly, the
number of bars at the bottom of the display increases one bar
at a time. Set the level for your water hardness by observing the
number of bars.
Press steam/rinsing button (Fig. 1/E) to conrm your choice.
Symbol S13
ashes on the display and symbol S7 is on.
Press steam/rinsing button (Fig. 1/E) for more than three seconds
to leave the main menu.
Depending on the presets, one, two or three beans are shown on the
display. The machine is now ready for use.
This function determines the automatic switch-o time after the last
use. The factory setting is “after 5 minutes”.
Press the steam/rinsing button (Fig. 1/E) for more than three
seconds to go to main menu. Release button.
Press steam/rinsing button (Fig. 1/E) repeatedly until symbol
S8
appears.
To change the switch-o time, press the coee cup button
(Fig.1/D) repeatedly.
!
i
To Next Page
Loading...
