Sprada Future TS4 - Adjusting the Temperature

7
Increase the number of bars at the bottom of the display, one bar at
a time according to personal preference:
1 bar = automatic switch-o time after 5 minutes
2 bars = automatic switch-o time after 30 minutes
3 bars = automatic switch-o time after 70 minutes
After three bars the display starts again with one bar.
 Press the steam/rinsing button (Fig. 1/E) to conrm your choice.
The bars will light up briey.
 Press the steam/rinsing button (Fig. 1/E) for more than three
seconds to leave the main menu.
Depending on the presets, one, two or three beans are shown on the
display. The machine is now ready for use.

Adjust the temperature as required to “normal”, “high”, or “maximum”.
The factory setting is “high”.
 Press the steam/rinsing button (Fig. 1/E) for more than 3 seconds
to go to main menu. Release button.
 Press the steam/rinsing button (Fig. 1/E) repeatedly until symbol
S9
appears.
 To change the temperature, press the coee cup button (Fig.1/F)
repeatedly.
Increase the number of bars at the bottom of the display one bar at
a time.
 Set the level for your preferred temperature in accordance with
the number of red bars.
1 bar = temperature “normal“,
2 bars = temperature “high“,
3 bars = temperature “maximum“.
After three bars the display starts again with one bar.
 Press the steam/rinsing button (Fig. 1/E) to conrm your choice.
The bars will light up briey.
 Press the steam/rinsing button (Fig. 1/E) for more than three
seconds to leave the main menu.
Depending on the presets, one, two or three beans are shown on the
display. The machine is now ready for use.

For additional hygiene, activate the automatic-o rinsing process
after the machine has been switched o.
The factory setting is “o”.
 Press the steam/rinsing button (Fig. 1/E) for more than three
seconds to go to main menu.
2. GETTING STARTED