9
Tip: When you use the machine for the first time or if it hasn’t
Once you have completed the instructions (section 2), the procedure
for switching the machine on is always the same:
Switch on using the on/o switch (Fig. 1/I).
The display shows five flashing red bars. When the system has reached
operating temperature, the display will show symbol S10
.
Press steam/rinsing button (Fig. 1/E).
The system rinses and the machine is now ready for use. Depending
on the presets, one, two or three beans are shown on the display.
The coffee strength can be set to three levels according to taste. As
soon as the machine is operational, the display will show either its last
preset or the factory setting.
MILD - the display features one bean, about seven grams of ground
coffee, e.g. for latte or cappuccino;
STANDARD - the display features two beans, about nine grams of
ground coffee, e.g. for a long coffee;
STRONG - the display features three beans, about 11 grams of
ground coffee, e.g. for espresso or strong coffee.
Change the setting by repeatedly pressing the strength/volume
selector (Fig. 1/B). The strength changes from mild (one bean
in display), to standard (two beans in display), to strong (three
beans in display) and back to mild.
By turning the strength/volume selector (Fig. 1/B), you can smoothly
adjust the amount of water dispensed (cup symbol bottom left for
minimum quantity of water, full cup symbol bottom right for maximum
water).
i
3. MAKING COFFEE
i
i
To Next Page
Loading...
