SPXFLOW C Series - Page 29

Maintenance Waukesha Cherry-Burrell
®
Brand C-Series Pump
01/2019 95-03008-IEC Page 29
4. Figure 43 shows the seal O-ring installed in the seal.
5. Assemble the spring, seal cup, O-ring, and carbon seal, and
install them as a unit, taking care that the slot in the seal cup
aligns with the pin on the drive collar
NOTE: On the C
-100, the slot will align with the pin on the
shaft.
NOTE: If necessary, apply gentle pressure on the O-ring to
overcome resistance on the shaft.
6. Figure 45 shows the slot in the seal cup aligned with the pin
on the shaft.
7. Lubricate and install the gasket on the backplate.
Figure 43 - Seal O-ring installed
Figure 44 - Install seal
Figure 45 - Slot and pin aligned
Figure 46 - Install gasket