SRAM HydroR - Prepare the Caliper

13
Caliper Piston Installation
Tighten the caliper body bolt.
Post mount only: Remove the banjo bolt o-ring. Apply grease to the
new o-ring and install it on the bolt. Install the bolt into the caliper.
Flat mount only: Remove the o-rings from the banjo bolt. Apply grease
to the new o-rings and install them on the banjo bolt so one is on each
side of the banjo fitting.
5
T25 9.8-11.8 N·m (86-104 in-lb) Post and Flat
6
DOT grease Post Mount
Post Mount
DOT grease Flat Mount
Flat Mount