SRAM HydroR - Page 36

36
Hose Installation
Connectamajig™ only: Calipers with a Connectamajig at the banjo must
replace the banjo when replacing the hose.
The caliper can be removed or remain installed on the frame or fork.
Remove the Connectamajig banjo. Apply grease to the new banjo
bolt o-ring(s) and install on the bolt. Install the bolt into the caliper and
tighten the new banjo.
DOT grease Flat Mount
Flat Mount
T25 9.8-11.8 N·m (86-104 in-lb) Flat Mount
8 mm 9.8-11.8 N·m (86-104 in-lb) Post Mount
8 mm Connectamajig
DOT grease
15