35
Hose Installation
Apply grease to the hose barb threads. Thread the hose barb into the
hose until it is flush with the end of the hose.
NOTICE
Do not overtighten the hose barb. Overtightening may cause damage
to the hose liner.
Install the banjo boot and compression nut onto the hose.
Thread the compression fitting over the hose barb,
counter-clockwise, until it is flush or slightly lower than the hose barb.
The compression fitting is reverse threaded.
Apply grease to the outside of the compression fitting and the threads
of the compression nut.
To Next Page
Loading...
