37
CLEANING AND MAINTENANCE
5.4 Cleaning the Roast Probe
After each use, the roast probe should be wiped with a warm, damp cloth and mild detergent, if necessary. The
roast probe is manufactured from stainless steel, with a special rubber casing for the electrical components.
Because of this the roast probe MUST NEVER BE IMMERSED IN WATER.
5.5 Removing Oven Door (downward opening door models only)
The oven door can be easily removed for better access while cleaning. To remove the oven door:-
1. Open the door fully and pull the clips toward you onto the hooks.
2. Raise the door slightly and, holding the sides of the door about half way up and making sure the clips stay on
the hooks, lift the door gently. This should disconnect the hinges from the oven frame.
3. Remove the door by continuing to raise it while pulling the door away from the oven. When handling the door
be careful not to dislodge the clips off the hooks. If so the hinge will have to be closed by hand and the clip re
engaged onto the hook before re-fitting onto the oven.
To re-fit the oven door:-
1. Holding the door at an angle to the oven, slide the hinges into the oven frame, making sure that on each side
the top, curved arm fits into the top slot and the lower arm fits into the bottom slot.
2. Make sure the hinges are pushed in as far as they will go and the lower arm engages into the plate mounted
in the oven frame.
3. Open the door completely and disengage the clips from the hooks. You may need to push the clips down with
your finger if they do not fall away from the hook by themselves. The door can now be opened and closed as
normal.
To Next Page
Loading...