ST STM32 Nucleo User Manual

List of tables
Table 1. Ordering information..................................................................3
Table 2. Codification explanation ...............................................................3
Table 3. ON/OFF convention ..................................................................5
Table 4. Default jumper settings ............................................................... 11
Table 5. ST-LINK jumper configuration .......................................................... 11
Table 6. CN3 SWD debug connector ........................................................... 12
Table 7. Power supply capabilities ............................................................. 13
Table 8. VCP communication ................................................................ 16
Table 9. Jumper configuration ................................................................ 17
Table 10. Solder bridge configuration and settings ................................................... 17
Table 11.
ARDUINO
®
connector pinout...........................................................20
Table 12. NUCLEO-C031C6 STM32 Nucleo-64 board I/O assignment ..................................... 22
Table 13. Document revision history ............................................................. 27
UM2953
List of tables
UM2953 - Rev 1
page 30/32

ST STM32 Nucleo Specifications

General

On-board Debugger	ST-LINK/V2-1
Microcontroller	STM32 Series (varies by model)
Connectivity	USB
Headers	Arduino Uno R3 and ST Morpho
Core	ARM Cortex-M (varies by model)
Operating Voltage	3.3V
Clock Speed	Varies depending on the STM32 MCU
Flash Memory	Varies depending on the STM32 MCU
SRAM	Varies depending on the STM32 MCU
GPIO Pins	Varies depending on the STM32 MCU
ADC Resolution	Varies depending on the STM32 MCU
DAC Resolution	Varies depending on the STM32 MCU
Communication Interfaces	SPI, I2C
Debug Interface	SWD