5 Quick start
This section describes how to quickly start development using NUCLEO-C031C6.
To use the product, the user must accept the Evaluation Product License Agreement from the www.st.com/epla
webpage.
For more information on the STM32 Nucleo-64 board and demonstration software, visit the www.st.com/
stm32nucleo webpage.
5.1
Getting started
Follow the sequence below to configure the STM32 Nucleo-64 board and launch the demonstration application
(Refer to Figure 3 for component location):
1. Check jumper positions on board: CN2 ST-LINK [1-2] and [3-4], JP5 PWR [1-2], and JP6 ON.
2. For correct identification of all device interfaces from the host PC, install the Nucleo USB driver available on
the www.st.com/stm32nucleo web page, before connecting the board.
3. To power the board, connect the STM32 Nucleo-64 board to a PC with a USB Type-A or USB Type-C
®
to
Micro-B cable through the CN1 USB connector. Once powered on, the LD3 PWR green LED lights up and
LD1 COM LED blinks.
4. Press the B1 blue user button.
5. Observe that the blinking frequency of the LD4 three green LEDs changes, by clicking on the B1 button.
6. The demonstration software and several software examples showing how to use the STM32 Nucleo features
are available from the NUCLEO-C031C6 product location.
UM2953
Quick start
UM2953 - Rev 1
page 6/32
To Next Page
Loading...
Need help?
General
