ST STM32MP157D-DK1 - ARDUINO Interface; Table 23. I;O Configuration of the ARDUINO; Figure 16. ARDUINO Connectors Pinout

6.16.3
ARDUINO
®
interface
Figure 16 shows the pinout of the ARDUINO
®
connectors.
Figure 16. ARDUINO
®
connectors pinout
ARDUINO
®
connector
(CN13)
ARDUINO
®
connector
(CN14)
ARDUINO
®
connector
(CN16)
ARDUINO
®
connector
(CN17)
Table 23
describes the I/O configuration of the ARDUINO
®
interface.
Table 23. I/O configuration of the ARDUINO
®
interface
I/O
HW Configuration
PF14 - PF14 is used as ARD_A0: ADC1_IN0
PF13 - PF13 is used as ARD_A1: ADC1_IN1
ANA0 - ANA0 is used as ARD_A2: ADC1_IN6
ANA1 - ANA1 is used as ARD_A3: ADC1_IN2
PC3 SB24 ON PC3 is used as ARD_A4: ADC1_IN13 Default configuration
PF12 SB26 ON PF12 is used as ARD_A5: ADC1_IN14 Default configuration
PE7 - PE7 is used as ARD_D0: UART7_RX
PE8 - PE8 is used as ARD_D1: UART7_TX
UM2637
ARDUINO® connectors
UM2637 - Rev 2
page 27/47