Stanley Pro MC521 User Manual

MC521 PRO Control Box
10.21.2015
1.800.7.ACCESS • www.stanleyaccesstechnologies.com • Document # 204066 REV D2 11
Copyright 2015, Stanley Security Solutions. All rights reserved. Reproduction in whole
or in part without the express written permission of Stanley is prohibited.
Table 4. Status Codes
Status Code Description Remediation IF Necessary
00 Normal operaon—All OK
0b Obstrucon
20 Breakout
33 System error See aachment 7
34 Internal Communicaon Error – Type 1 See aachment 7
35 Motor Drive Failure Replace Controller
36 Internal Communicaon Error – Type 2 See aachment 7
A0 First installaon sequence (FIS)
A1 Auto-conguraon sequence
A2 Auto-conguraon conrmaon sequence
b1 Encoder error
Ld Lock Down (Shear Lock Energized)
dc Display door cycle counter
dE Delayed Egress
dL Shear Lock De-Energized
E1 Upper hold beam sensor error Verify sensor wiring and safety logic seng
E3 Door length error Re-do rst installaon sequence (FIS)
F0 Inside Monitored sensor failure Verify sensor wiring and safety logic seng
F1 Outside Monitored sensor failure Verify sensor wiring and safety logic seng
F2 Upper Photo Beam Pro sensor failure Check transmier, receiver, and hold beam type
F3 Lower Photo Beam Pro sensor failure Check transmier, receiver, and hold beam type
ho Door held open Check sensors and hold beam type
Table 5. Door States
Door State Description
00 Door State is Closed
02 Door State is Opening
03 Open Braking
04 Door State is in Open Check
06 Door State is Full Open
07 Door State is Closing
09 Door State is in Close Check
15 Door State is in Open Stop
16 Door State is in Recycle or Obstrucon While Closing
17 Door State is in Close Press
NOTE: If the current status code is “Normal operaon—All OK”, the MC521 Pro will show the current door state.
Otherwise, the MC521 Pro alternates between showing the current status code and the door state.

Stanley Pro MC521 Specifications

General

Brand	Stanley
Model	Pro MC521
Category	Controller
Language	English