Stanley Pro MC521 User Manual

MC521 PRO Control Box
8 Document # 204066 REV D2 • www.stanleyaccesstechnologies.com • 1.800.7.ACCESS
Copyright 2015, Stanley Security Solutions. All rights reserved. Reproduction in whole
or in part without the express written permission of Stanley is prohibited.
10.21.2015
Step 15: Press SUMMARY to view all current
sengs.
Step 16: Review the informaon on the
Summary lisng.
Tuning In the MC521 Pro Controller Using the Controller Pushbuttons
NOTE:
1. To change the INDEX:
Hold ENTER switch while pressing UP or DOWN to get to desired INDEX.
2. To change a VALUE:
Unlock the keypad by seng index 99 to value 00.
Aer the desired INDEX is selected, release ENTER and within 2.5 seconds press UP or DOWN to get the
desired VALUE. (If the UP or DOWN buons are not pressed within 2.5 seconds of releasing the ENTER buon,
the display will change from the VALUE back to the STATUS.)
3. To display STATUS CODE:
A few seconds aer the VALUE is selected, the display indicates the STATUS CODE.
4. To show the INDEX and VALUE.
To show the INDEX, hold ENTER. Once ENTER is released the display will show the VALUE of that INDEX.
5. Read the descripons enrely before performing each step. Check the INDEX and VALUE aer each step.
6. To STORE CHANGES in permanent memory:
Cycling door open one me will store changes.
7. To LOCK keypad:
Lock keypad by seng index 99 to value 01 or by turning power OFF and then ON.
8. To ACCESS the door cycle counter funcon:
a. Ensure that the keypad is locked by seng index 99 to 01.
b. Ensure that the index is set to any index but 99.
c. Press the up or down key to access the door cycle counter.
The display will show “dc” followed by four pairs of digits, followed by “dc”.
Example: If the Door count was 12345678 cycles the controller will display “dc” “12” “34” “56” “78” “dc”.
15

Stanley Pro MC521 Specifications

General

Brand	Stanley
Model	Pro MC521
Category	Controller
Language	English