Star Micronics BSC10 Series - Ethernet Link Disconnection Feature

- 7 -
3-2-4. Ethernet Cable
To connect the cable, follow the procedure given below.
1) Make sure that the AC adapter’s power cord is not connected to the outlet.
2) Connect the Ethernet cable to the Ethernet port.
■ Link disconnection detection feature
The Ethernet interface model is equipped with a link disconnection detection feature.
If the printer is turned on when an Ethernet cable is not connected to it, the POWER and ERROR lamps are simultaneously
turned on and off at 4-second intervals to indicate the disconnection. Be sure to connect the Ethernet cable from a PC or hub
to the printer, and then turn the printer on.
IftheIPaddressisnotrecognizedcorrectly,thePOWERandERRORlightscontinuetoashsimultaneouslyevery0.25
seconds indicating that the link is broken. After setting the correct IP address, restart the printer.
Ethernet cable