– 52 –
MAINTENANCE AND LUBRICATION
Grease
2. Lubrication
Lubrication is very important to maintain optimum performance and to prevent trouble.
2-1. Lubricant
The type of lubricant greatly affects the performance and durability of the printer, especially in a low temperature
environment. We recommend use of the grease and lubrication oils listed below for this printer.
Type of oil Product name Maker
FLOIL GB-TS-0 Kanto Chemicals Co., LTD.
KF96 (1000 cs) Shinetsu Chemical Industry
Lubricant Mobil 1 Mobil oil
2-2. Lubricating Method
When lubrication is carried out in assembly and disassembly, wash parts well to remove dust and dirt before lubrication.
Lubrication must be carried out regularly once every 6 months or after 1 million lines have been printed. Lubrication is
necessary irrespective of the regular lubrication whenever lubricant becomes deficient after cleaning or whenever parts
have been disassembled or replaced.
2-3. Lubricated Areas
NO. Lubricating Point Grease/Oil
[1] Rubbing surface of TM pulley B and pulley shaft GB-TS-0
[2] Rubbing surface of pulley cap and stop ring GB-TS-0
[3] Rubbing surface of gear 58 × 0.5 and gear shaft GB-TS-0
[5] Rubbing surface of lift cam and shaft KF96
[6] Rubbing surface of gear B and shaft GB-TS-0
[7] Rubbing surface of gear A and shaft GB-TS-0
[8] Rubbing surface of ribbon change lever and carriage KF96
[9] Rubbing surface of lift lever and shaft KF96
[10] Rubbing surface of lift lever and carriage KF96
[11] Rubbing surface of lift lever and lift cam KF96
[12] Rubbing surface of ribbon change lever and lift cam KF96
[13] Rubbing surface of gear cover and three gears GB-TS-0
[14] Rubbing surface of adjusting lever and frame GB-TS-0
[15] Rubbing surface of bushing and carriage stay Mobil 1
[16] Rubbing surface of tractor frame assy and shaft GB-TS-0
[17] Rubbing surface of idler gear 16 × 72 × 0.5 and shaft GB-TS-0
[18] Rubbing surface of idler gear 36 × 0.5 and shaft GB-TS-0
[19] Rubbing surface of color ribbon holder and carriage GB-TS-0
[20] Rubbing surface of PF idler gear 28 × 0.5 and shaft GB-TS-0
[21] Rubbing surface of PF clamp lever and shaft GB-TS-0
[22] Rubbing surface of roller holder and lower case GB-TS-0
To Next Page
Loading...
