Table of Contents
Chapter 1
Chapter 2
Setting Up SG-lo/15
1
Where Shall We Put It?
What Have We Here?
Removing the printer cover
Removing packing and shipping screws
Installing the platen knob
Removing the tractor unit
Attaching the paper separator and paper guide
Installing the ink ribbon
Getting to Know Your SG-lo/15
9
Components and Controls
Paper Selection and Loading
Loading single sheets
Loading sprocket-feed paper
Bottom feeding SG- 15
Adjusting the Gap
Self-Test
Chapter 3
Chapter 4
Getting Started With SG-lo/15
23
Using Commercial Software
First, some terminology
Using SG- lo/ 15 with SuperCalc
Using SG-IO/15 with word processors
Using this book without learning BASIC
-
Controlling SG10/15 With BASIC
29
Some Basics About BASIC
Establishing communications
The CHR$ function
Control codes
The escape code
Chapter 5
Some problem codes
Command Syntax Used in This Manual
Selecting The Right Software Mode
Printing Text With SG-lo/15
Some Special Kinds of Text
Near Letter Quality characters
Italic printing
37
-
-
.-
-
-.
-
To Next Page
Loading...
