– 38 –
LINE MODE
2) Use N=3 for folloing settings
n1 :Character table
n2 :Character table
n3 :Print column
n4 :Line feed, CR code
Note: In order to enable the changed memory switch setting, turn
the printer OFF and ON again or send the printer reset
command (<ESC>“?”) to the printer.
3) Use N=4 for folloing settings (TSP700 only)
Setting 0 1 2 3
n1 Always “0”
-
n2 Always “0”
-
n3 Print colum See bolow (ESC/POS mode only)
n4 Print area See bolow
n4 Print area Roll paper width
0 72 mm (576 dots) 80 mm
1 52.5 mm (420 dots) 58 mm
2 80mm (640 dots) 82.5 mm
3 50.8 mm (406 dots) 58 mm
n3 Print colum Print area Left margin Font-A Font-B
0 EPSON
72
mm
(576
dots
)
32 dots 42 colums 56 colums
compatible
52.5
mm
(
420dots
)
24 dots 31 colums 41 colums
80 mm
(640
dots
)
40 dots 47 colums 63 colums
50.8
mm
(
406dots
)
24 dots 30 colums 40 colums
1 Max.
72
mm
(576
dots
)
0 dot 48 colums 64 colums
colum
52.5
mm
(
420dots
)
0 dot 35 colums 46 colums
80 mm
(640
dots
)
0 dot 53 colums 71 colums
50.8
mm
(
406dots
)
0 dot 33 colums 45 colums
Setting 0 1 2 3
n1
Character table See the table 1 (Nest page)
n2
n3 Print colum 69 (TSP800) 55 (TSP800)
––
33/35/48/53 27/28/38/42
(TSP700) (TSP700)
n4 Line feed (mm) 4 3 4 3
CR code Invalid Invalid Valid Valid
To Next Page
Loading...
