13
To view manuals, videos, drivers, downloads, technical drawings, and more visit www.startech.com/support
Manually Setting up the Print Server
1. Connect a CAT5e/6 Cable to the RJ45 Port on the Print
Server and to a Computer.
2. Set your network adapter to the following settings:
• IP Address: 169.254.xxx.xxx
• Subnet Mask: 255.255.0.0
• Gateway: n/a
3. Go to the Command Prompt(on Windows) or Terminal (on
macOS) and enter the command arp –a. The Print Server’s
IP Address and MAC Address will appear. The MAC Address
will match the one on the bottom of the Print Server.
Note: The Print Server may take serveral minutes for it to
appear in the arp table.
4. Access the web interface by entering the IP address you got
from the previous step in the address bar of a web browser.
5. Set the print server to a static IP address within the subnet
your computer & networking equipment is on (For further
information, refer to the section Viewing/Conguring
Network Settings to change the Print Server’s IP Address).
6. Change the IP address for your network adapter back to its
original IP address.
7. Disconnect the CAT5e/6 Cable from the Computer and
connect it into a RJ45 Port on a Router or Network Device.
8. Add the printer using Operating System (OS) specic steps.
To Next Page
Loading...