Steinberg CMC Series User Manual

CMC-FD
CMC Series Operation Manual 11
6 [SHIFT] (Shift button)
When you operate an optional control while holding
down this button, an extra function that the control
provides (referred to as SHIFT function) is executed. For
details on the SHIFT functions for each control, refer to
the section “SHIFT functions of each control.”
7 [CHANNEL <] 8 [CHANNEL >]
(Channel button)
Shifts the channel bank toward the right and left by one
channel.
9 [BANK <] ) [BANK >] (Bank button)
Shifts the channel bank toward the right and left by the
bank size (four channels per device).
NOTE
• Refer to “How to operate the device and editor” on
page 6 for instructions on using the fader.
• Be sure to operate the faders with bare hands. The
faders will not work properly if operated with gloved
hands.
SHIFT functions of each control
Moving the channel bank to the selected channel
Fig. 3
Fig. 4
Controls SHIFT functions
Fader With slide operation, this allows finer
adjustment of the level of selected
channel.
With tap operation above the middle
point, this turns Mute on or off. Both ends
(the upper and lower sides) of the fader
light during Mute.
With tap operation below the middle
point, this turns Solo on or off. The fader
value flashes during Solo.
[CHANNEL
<]
Moves the channel bank to the channel
selected on Cubase.
The selected channel is assigned to
2,
and the next channels of the selected
channel are assigned to
3 – 5. (Refer to
Fig. 3)
When the selected channel stays in on
the extreme right of Mixer, the selected
channel is assigned to
5, and the
channels in front of the selected channel
are assigned to
2 – 4. (Refer to Fig. 4)
[CHANNEL
>]
Switches between the fader function and
the level meter function.
While in the level meter function, level
information of an assigned channel
appears on the fader in real time.
Fader position of the corresponding
channel appears for a certain period, if
you operate the fader while it functions as
a level meter.
Controls SHIFT functions
[BANK <] Switches the fader operation mode
between Catch and Jump.
2345
2345
Channel bank
Selected channel
2345
2345
Channel bank
Selected channel

Steinberg CMC Series Specifications

General

Brand	Steinberg
Model	CMC Series
Category	Controller
Language	English