CMC-QC
CMC Series Operation Manual 27
3 [Q] (QC mode button)
Sets to the QC mode, and lights when in the QC mode.
4 [f/Q LEARN]
(In the QC mode: QC Learn)
(In the EQ mode: f/Q button)
In the QC mode, this turns on or off “QC Learning,”
which assigns to Quick Control the parameter currently
located with the mouse pointer. See “Assigning a Quick
Control with QC Learning” on page 28 for the QC
Learning operation.
In the EQ mode, this switches the parameters operated
via knobs [5] – [8]. You can operate Q (bandwidth) when
it’s on, and Frequency when it’s off.
NOTE
The QC Learning is compatible with Cubase version 6.0
or later and Cubase Artist version 6.0 or later only.
5 [EQ] (EQ mode button)
Sets to the EQ mode, and lights when in the EQ mode.
6 [MIDI] (MIDI mode button)
Sets to the MIDI mode, and lights when in the MIDI
mode.
7 [F1] 8 [F2] 9 [F3] ) [F4] (Function 1/ 2/ 3/ 4
button)
Controls the DAW by assigning a user command.
You can assign a desired command from among “Key
Commands” of Cubase ([Key Commands…] under the
[File] menu) to each button. To control functions 5 – 8 (F5
– F8), press this button while holding down [SHIFT]. By
default, the functions of the Transport are assigned as
shown in the following table.
NOTE
For instructions on editing the user commands, refer to
“Editing User Commands” on page 35.
! [SHIFT] (Shift button)
When you operate an optional control while holding
down this button, an extra function that the control
provides (referred to as SHIFT function) is executed. For
details on the SHIFT functions for each control, refer to
the section “SHIFT functions of each control.”
SHIFT functions of each control
@ # [CH SELECT] (Channel Select
button)
Shifts the selected channel forward/ back by one level.
$ [R] (Read Automation button)
Turns Read Automation on or off, and lights when on.
% [W] (Write Automation button)
Turns Write Automation on or off, and lights when on.
Button Command
[F1] Fast Rewind
[F2] Fast Forward
[F3] Stop
[F4] Start
[SHIFT] + [F1] (F5) Step Back Bar
[SHIFT] + [F2] (F6) Step Bar
[SHIFT] + [F3] (F7) Cycle
[SHIFT] + [F4] (F8) Record
Controls SHIFT functions
Corresponding
mode
Knob Finely adjusts parameter. QC/EQ/MIDI
[Q] Turns EQ band 1 on or off. EQ
[f/Q
LEARN]
Turns EQ band 2 on or off. EQ
[EQ] Turns EQ band 3 on or off. EQ
[MIDI] Turns EQ band 4 on or off. EQ
[F1] Executes the user
command F5.
QC/EQ/MIDI
[F2] Executes the user
command F6.
QC/EQ/MIDI
[F3] Executes the user
command F7.
QC/EQ/MIDI
[F4] Executes the user
command F8.
QC/EQ/MIDI
To Next Page
Loading...
Need help?
General
