Steinberg CMC Series User Manual

CMC-QC
CMC Series Operation Manual 28
Assigning a Quick Control with QC
Learning
The QC Learning function allows you to assign any
parameter to a quick control by using a knob in the QC
mode.
Instructions on assigning are described below.
1. Press [Q] to enter the QC mode.
2. Press [f/Q LEARN] to turn QC Learning on.
3. Locate the mouse pointer on the desired
parameter of Cubase to which you want to
assign to the knob.
NOTE
• Assignable parameters are limited to those which
can be automated.
• The plug-in parameter must be compatible with
VST3 or above.
4. Turn the desired knob.
A parameter will be assigned to the Quick Control,
corresponding to the knob turned, for the selected
track. The knob will flash, then lights if the
assignment was successful.
5. Press [f/Q LEARN] once again to turn QC
Learning off.
To cancel the parameter assignment, click the desired
slot of the Quick Control on Cubase, then select “No
Parameter”.
NOTE
• When overwriting a different parameter onto a knob to
which a parameter is already assigned, repeat the
above steps.
• You can control the parameter already assigned even
when performing QC Learning.
• To prevent other parameters from being overwritten
accidentally, turn off QC Learning while not performing
parameter assignments.
The initial parameter settings of MIDI
mode
The CMC-QC allows Control Change parameters to be
assigned to each knob in the MIDI mode. The initial
settings are shown in the following table.
To edit parameters, use the CMC-QC Editor. See “CMC-
QC Editor” on page 29 for details.
Knob
KNOB
LED
CC NUMBER
MIDI
CH
MAX MIN
1 1 74 (Brightness) 1 127 0
2 1 71 (FilterResonance) 1 127 0
3310 (Pan) 11270
4 1 07 (Level) 1 127 0
5 1 73 (AttackTime) 1 127 0
6 1 72 (ReleaseTime) 1 127 0
7 1 91 (ReverbSendLevel) 1 127 0
8 1 93 (ChorusSendLevel) 1 127 0

Steinberg CMC Series Specifications

General

Brand	Steinberg
Model	CMC Series
Category	Controller
Language	English