CMC-CH
CMC Series Operation Manual 9
User Commands
You can assign a desired command from among
“Key Commands” of Cubase ([Key Commands…]
under the [File] menu) to each button.
The initial settings of CMC-CH’s user commands
are the following.
NOTE
For instructions on editing the user commands,
refer to “Editing User Commands” on page 35.
Button Category Command
F1 Transport Fast Rewind
F2 Transport Fast Forward
F3 Transport Stop
F4 Transport Start
F5 Transport Cycle
F6 Edit Snap On/ Off
F7 Transport Metronome On
F8 Edit Autoscroll
To Next Page
Loading...
