Operation
Loading Operation Continued...
Fully
retract lift
cylinder
Fully
extend jib
cylinder
Once fully attached, push the ‘Lift’
control lever to load the body.
Note: Make sure the body is lining
up with the rear rollers while loading.
Finally, push the control
lever labeled ‘Jib’ to slide
the jib forward until the
body latches fully engage.
Disengage the PTO.
Note: If the container
will experience a signif-
icant restriction to
movement during load-
ing, the foot brake must
not be used. Allow the
truck to roll under the
load.
Note: Hook and bail heights must match.
To Next Page