Slider26 Owner’s Manual
0
5000
10000
15000
20000
25000
05001000150020002500300035004000
OPERATING PRESSURE (PSI)
LOADER CAPACITY (POUNDS)
36" HH
54" HH
62" HH
Never Exceed the Maximum Pressure of 3900 psi.
Never adjust System Relief
Pressure to allow Hooklift
Capacity to exceed chassis
GVW and always perform a
weight distribution before
installation and after System
Relief Pressure adjustments to
confirm Hooklift Capacity and
chassis compatibility.
Step 14: Operate hooklift.
a. Bleed the air out of the hydraulic system.
b. Check the oil level and add oil if needed.
c. Calibrate dump light system.
d. Be sure to check all clearances.
e. Set/check relief pressure no higher than 3900 PSI (See chart below and steps on following
pages ).
a. Fill reservoir to site gauge, within 3” from the top (Roughly 25 Gallons).
Note: Petro-Canada Hydrex 32 (ISO 32) hydraulic oil is recommended.
b. When connections are secure, activate hydraulic flow by opening the ball valve on the
bottom of the reservoir. This will allow oil to flow from the reservoir to the pump.
Step 13: Fill reservoir and activate hydraulic flow.
To Next Page
Loading...