Slider26 Owner’s Manual
Loading Operation
Fully
retract jib
cylinder
Back truck
to body.
Maneuver the truck into a position to load the
body. Put the truck in neutral and engage the
PTO.
Pull the control lever labeled ‘Jib’ to slide the jib as far
back as it will go, effectively releasing the dump latches.
Slowly back up and attach
to the body by using the
‘Lift’ control lever as neces-
sary.
Extend lift
cylinder
Pull the control lever labeled ‘Lift’
until the hook is in a position to
attach to the body.
Note: Hook and bail heights must match.
To Next Page