Slider26 Owner’s Manual
Unloading Operation
Put the truck in neutral and engage the PTO.
Pull the control level labeled
‘Jib’ to slide the jib as far
back as it will go, effectively
releasing the dump latches.
Pull the control lever labeled ‘Lift’
until the body is on the ground.
Fully
retract jib
cylinder
Note: If the container
will experience a signif-
icant restriction to
movement during
unloading, the foot
brake must not be
used. Allow the truck to
roll out from under the
load.
Extend lift
cylinder
To Next Page
Loading...