WORKSHOP MANUAL
4 - MAINTENANCE
EDITION
PAGE
21 /37
2. Release the two positioning cables (4) from
the lower frame (5) of the belt guard, taking
care not to drop them inside the casing under-
neath.
3. Release the pin (6) freeing it from the retaining
notches (7).
4. Release all plastic profiles (8) that fasten the
canvas (9) to the lower frame (5).
5. From the upper part of the guard, extract the
two elastic eyelets (10) from their respective
seats (11).
6. Using a suitable pair of pliers, release the re-
taining tabs (12) on the inside and remove one
of the two forks (13).
7. Remove the canvas from the frame.
Reassemble the new canvas and fasten the guard
following the above procedures in reverse order.
To Next Page
Loading...
