WORKSHOP MANUAL
4 - MAINTENANCE
EDITION
PAGE
25 /37
7. Remove the belt from the central pulley (15),
pulling it out between the teeth of the toothed
wheel (16) on the locking device.
Reassemble the new belt respecting the path in-
dicated on the upper casing, following the above
procedure in reverse order.
When reassembling the belt guide (4), take care to re-
store the washer (3a) under the right screw (3), to prevent the
screw tip from interfering with the underlying mechanisms.
The locking device has the purpose of blocking the rotation of the blades if the cutting deck is ac-
cidentally moved to the washing position with the blades engaged.
- This device is an integral part of the safety devices of the machine and
therefore must always be kept in perfect working order.
Repeated interventions on the device, due to incorrect use, can deteriorate the teeth of
the toothed wheel and damage the engage-
ment cable.
For this reason, in case of intervention, it is
not possible to replace the components indi-
vidually, but the special kit must be used to
restore the original factory default settings
with the replacement of all the parts involved.
To Next Page
Loading...
Need help?
General
