WORKSHOP MANUAL
4 - MAINTENANCE
EDITION
PAGE
35 /37
1. Safety checks 5/– 100/12
• Safety measures to be adopted
2. Check all fasteners 5/– 100/12
• Tightening torques
3. Control checks 5/– 100/12
• Locking device function check
• Cutting height adjustment func-
tion check
4. Transmission belt check 5/– 100/12
• Check for initial signs of break-
age
• Replacement of the control belt
• Replacement of the blade con-
nection belt
5. Check the condition of
the cutting-means
5/– 100/12
• Sharpening and balancing the
blades
• Check the alignment of the blade
shafts
6. Lubrication of moving
parts
–/– 100/12
• Lubrication
7. General cleaning and
inspection
5/– 100/12
• Wash cycle
Standard practice requires that all moving parts are always well lubricated, making sure that there
are no interruptions in the actuation of the various mechanisms.
In addition, the following interventions should be carried out:
100 hours
or seasonal
Lubrication of the front wheel
rods
Grease
100 hours
or seasonal
Lubrication inside the cable
terminals and smooth sliding
test
Oil
To Next Page
Loading...
