WORKSHOP MANUAL
4 - MAINTENANCE
EDITION
PAGE
36 /37
Washing the inside of the cutting decks must be carried out with the plate in the "Maintenance /
Washing" position, using a water jet cleaner only.
Never use high pressure jets of
water. This could damage the electrical compo-
nents. Only use water and a brush with non-me-
tallic bristles.
When the washing is finished, lower the cutting
deck, engage the blades and allow them to run
for at least 2 minutes, to allow the water to drain
from the bearings and rotating parts.
If wear and tear has caused scratching or remov-
al of paint, touch-up the area when it is perfectly
clean and dry.
To Next Page
Loading...
