WORKSHOP MANUAL
1 - INTRODUCTION
EDITION
PAGE
6 /37
The Warranty registration card must be completed, signed and returned at the time of purchase.
This activates the warranty card.
Claims that meet the requirements will be honoured during the limited warranty period.
The Manufacturer acknowledges the interventions performed under warranty as per the terms,
procedures and limits stated in the contract.
• The warranty does not cover damages caused by:
- Lack of knowledge and familiarisation of the accompanying documentation on the part of the
user.
- Carelessness.
- Incorrect or prohibited use or assembly.
- Use of non-genuine spare parts.
- Use of accessories not supplied or approved by the manufacturer.
• The warranty does not cover components normally subject to wear and tear such as blades,
belts and so on.
The purchaser is covered by national legislation of the Country he resides in. The legal rights of
the laws that refer to the purchaser are not limited by this product warranty.
The Service Centre has to make out a report containing the machine serial number, a summary of
the problems, the repairs carried out and any spare parts used for each repair done on the equip-
ment.
A copy of these reports must be retained and made available to the Manufacturer together with
the replaced parts in case of any subsequent disputes with Customers.
The Manufacturer welcomes any notifications of faults that recur with particular frequency. It gives
the opportunity for a careful inspection of the problem and the implementation of corrective action
at production level.
Similarly, the Manufacturer will report any faults discovered on the machines produced, with rec-
ommendations for the most suitable procedures for their remedy.
When requesting spare parts, the code number must be given, referring to the exploded charts for
the year of manufacture, shown on the product identification label.
To Next Page
Loading...
Need help?
General
