EasyManua.ls Logo

Stiga Villa Spring - Checking the Engine Oil Level (18; 19; 19 A); Electrical Safety Check; General Safety Check; Safety Checks

Stiga Villa Spring
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
NOTE! Petrol is perishable and should
not remain in the tank for more than 30
days.
It is possible to use ecological fuels, i.e. alkylate
petrol. The composition of these petrols is less
harmful to people and the environment.
No negative eects linked to use of the same
have been reported. However, there are types
of alkylate-based petrol available on the market
for which it is not possible to give precise indica-
tions regarding their use.
For further information it is advisable to consult the
instructions and data provided by the producer of
the alkylate-based petrol.
Never ll the tank right to the top.
Leave a little space (equal to at least the whole
depth of the top-up mouth + 1 - 2 cm from the top
of the tank) so that when the petrol heats up it has
room to expand without overowing.
If you plan on putting the machine away
for a prolonged period (e.g. over the
winter), only put enough fuel in the tank

In fact, before storing the machine it is
a good idea to empty the fuel tank com-
pletely (see 10).
7.4 CHECKING THE ENGINE OIL LEVEL
(18; 19; 19A)
The machine is delivered complete with engine oil.
Before starting the machine check the
level of the engine oil.
To check / top up the engine oil, see
9.5.1.
7.5 SAFETY CHECKS
When trying out the machine, check that the
results of the safety checks correspond with the
indications provided in the following tables.
Always carry out the safety checks be-
fore use.
If any of the results fails to match the
indications provided in the following ta-
ble, do not use the machine!
Take it to a service centre to be checked
and repaired if necessary.
7.5.1 General safety check
Object Result
Fuel lines and
connections.
No leaks.
Electrical cables All insulation intact.
No mechanical damage.
Exhaust system. No leaks at connections. All
screws tightened.
Oil lines No leaks. No damage.
Drive the ma-
chine forwards/
backwards and
release the driving
pedal.
The machine will stop.
Test driving No abnormal vibrations.
No abnormal sound.
7.5.2 Electrical safety check
Status Action Result
The clutch-brake
pedal is not pres-
sed.
The PTO is not
activated.
Try to start
the machine.
The engine
does not
start.
The gear selector
is not in neutral
position
The PTO is acti-
vated..
Try to start
the machine.
The engine
will not start.
Engine switched
on. The PTO is
activated.
The driver
gets o the
seat
The engine
will not start.
Engine switched
on. The PTO is
activated
The driver
gets o the
seat
The engine
will not start.
Engine switched
on.
Remove the
20A fuse
(1:L).
The engine
stops
7.6 START-UP / OPERATION
When using the machine, the bonnet
must be closed and fastened shut.
Always use full throttle when using the
machine.
When starting the machine, wait for
2 seconds in starting position before
starting the engine.
EN
ENGLISH
(Translation of the Original Instructions)
16

Table of Contents

Related product manuals