1. Open the fuel cock (16).
2. Check that the spark plug cables are instal-
led on the spark plugs.
3. Check the PTO is disengaged (12:A; 13:A).
4. Do not keep your foot on the service/drive
brake (10:F)
Cold start
1. Engage the transmission (14:A)
2. Activate the parking brake (11:B)
3. Put the choke on (where applicable) (12:D;
13:C).
4. Turn the key in the ignition and start the en-
gine.
5. When the engine is running, gradually acce-
lerate to maximum operating speed
Before starting work with the machine,
wait a few minutes for the oil to warm
up.
Warm start.
1. Engage the transmission (14:A)
2. Activate the parking brake (11:B)
3. Turn the throttle to full on (12:D; 13:C).
4. Turn the key in the ignition and start the en-
gine.
To proceed see the instructions provi-
ded in heading 7.6.1.
7.6.1 Operation
To start the machine, proceed as follows:
Only for models: [Gear]
• Put into gear with the gear lever (12:B)
1. Press the pedal (11:B) right down then rele-
ase it.
2. Activate the pedal (13:E) to move the ma-
chine.
3. Go to the work area.
4. If front accessories have been installed, acti-
vate the PTO (12:A; 13:A)
5. Commence work.
7.7 STOPPING
To stop the machine, proceed as follows:
1. Disengage the PTO (12:A; 13:A)
2. Engage the parking brake (11:B)
3. Allow the engine to idle 1-2 mins.
4. Turn o the engine by turning the ignition
key.
5. Close the fuel cock. This is particularly impor-
tant if the machine is to be transported on a
trailer for example.
If you have to leave the machine unat-
tended, disconnect the spark plugs and
remove the key from the ignition.
The engine may be very warm immedia-
can cause burn injuries.
7.8 CLEANING
-
ne, silencer, battery and fuel tank free
from grass, leaves and oil
check the machine for oil and/or fuel
leaks.
Never use high-pressure water jets.
This can damage shaft seals, electrical
components or hydraulic valves.
Always clean the machine after use. To clean
the machine adhere to the instructions provided
below:
• Do not spray water directly onto the engine.
• Clean the engine with a brush and/or
compressed air.
• Clean the motor cooling air intake.
• After cleaning using water, start the machine
and any cutting device assy to remove any
water which may otherwise end up in the
bearings and cause damage.
8 USING THE ACCESSORY
Make sure the grass to be cut is com-
pletely free of foreign objects such as
stones etc.
8.1 CUTTING HEIGHT
For best results, cut o the top third of the grass.
See g. 23.
If the grass is long and needs cutting back signi-
cantly, cut twice using two dierent cutting heights.
Do not use the lowest cutting heights if the lawn
surface is uneven.
This would entail a risk of the cutting devices being
damaged against the surface and the lawn’s top
layer of soil being removed.
8.2 MOWING TIPS
To get the best mowing results, follow the tips
given below.
EN
ENGLISH
(Translation of the Original Instructions)
17
To Next Page
Loading...
