BGA 86 17
N Fit the press screw (14).
N Press the blower wheel (6) onto the motor’s shaft as
far as stop.
N Remove the press screw (14).
N Check correct installed depth of 12 mm with sliding
caliper, repeat press-fitting procedure if necessary.
N Check operation: The blower wheel rotates freely
without touching the blower housing.
N Pass the wires through the opening (arrow) in the
cover (2).
N Line up the cover (2). The cable guides (15) in the
cover (2) and the blower housing (4) are in alignment.
N Push cover (2) into the blower housing as far as stop.
N Install the outlet cone, @ 8.3.
N Install the inlet cone, @ 6.8.
N Install the blower tube, @ 6.9.
N Install the blower, @ 6.10.
N Install right handle housing, @ 6.11.
To Next Page
Loading...
