Cleaning the Forklift
Cleaning depends on the type of use and the
workplace. Should the truck come into contact
with highly aggressive elements such as salt
water, fertilizers, chemical products, cement,
etc., it should be cleaned as carefully as pos-
sible after every work cycle. It is preferable to
use cold compressed air and detergents. Use
water-dampened rags to clean the parts of the
body.
CAUTION
Do not clean the truck with direct jets of water; DO
NOT use solvents and petrols that could damage
parts of the truck.
General information on batteries
You can choose different types of batteries.
These must strictly comply with manufacturer
instructions.
Please comply with the details and properties
indicated on the battery type label.
NOTE
●
Battery maintenance or charging can only
be performed by qualified personnel in ac-
cordance with these instructions and the
battery manufacturer’s instructions.
●
Refilling batteries with an electrolyte solu-
tion is prohibited if they are a type that does
not require maintenance.
●
Batteries are recycled in accordance with
national regulations; please comply with the
relevant regulations.
●
Open flames are prohibited when handling
batteries, as the gas may cause an explo-
sion.
●
Non-flammable materials or liquids may be
stored in locations where batteries are
charged.Smoking is prohibited in these lo-
cations, which must also be kept ventilated.
●
Please stop the vehicle before starting to
charge or install/replace batteries.
●
Before completing maintenance work,
please ensure that all cables are connected
correctly and do not interfere with other
parts of the vehicle.
●
Fire-fighting equipment must be prepared.
NOTE
The truck must be parked in a suitable and
safe place when batteries are being handled.
CAUTION
Metal or conductive objects must not be placed on
top of the battery in order to prevent the battery from
short circuiting.
Operation
4
Cleaning the Forklift
46 50028011505 EN - 03/2022 - 06
To Next Page